The system detects lighting conditions and automatically draws power from available solar energy or the battery as required.

When enabled, the sight shuts down after ten minutes without movement and automatically wakes when motion is detected.

The dot remains fast to acquire at close range without unnecessarily covering the target during more precise aiming.

True 1× magnification and unlimited eye relief support a natural shooting position and retained peripheral awareness.

Ten daylight levels cover changing light conditions, while the two lowest settings are night-vision compatible.

The Crossfire II can be used independently or paired with a compatible red dot magnifier.

Anti-reflective coatings support light transmission and a clean sight picture in changing conditions.

The ultra-hard exterior coating helps protect the lenses against scratches, oil and dirt.

The sight is classified as Parallax Free according to the accepted industry standard for red dot sights.

The sealed, nitrogen-purged construction is intended for demanding weather and field conditions.

The low mount suits platforms that require a lower sighting line.

The raised mount is intended for configurations requiring a Lower 1/3 Co-Witness height.

Both supplied mounts attach to a firearm equipped with a compatible Picatinny or Weaver rail/base.

Any alternative mount must match the Micro T-2 footprint and the intended firearm platform.

Pressing either the “+” or “−” button powers the sight on. The same buttons control its twelve brightness levels.

Holding the “−” button for approximately three seconds manually powers the unit off and disables motion activation.

The feature works after the sight has entered automatic shutoff following ten minutes without movement. New movement wakes it again.

Each audible windage or elevation click changes the average point of impact by 1/2 MOA.